Ga naar inhoud

henridonne@gmail.com

Lid
  • Items

    4
  • Registratiedatum

  • Laatst bezocht

Over henridonne@gmail.com

  • Verjaardag 14-08-1939

henridonne@gmail.com's prestaties

  1. Beste, Het uitschakelen door middel van een schakelaar verhinderd dat de computer door een blikseminslag etc een te grote spanning zal krijgen waardoor de computer vernield zou geraken. Zowiezo beter als je de computer uitzet om hem uit het stopcontact te trekken of om een schakelaar af te zetten op je verdeelstekker. mvg, Mattias Eyckmans CEO Memory Leak VZW i.o. van Henri Donné
  2. Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of info, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are a very good approach to what a professional would say about your hard disk status. NOTE: this is a sample result using default hard disk data. In order to get a real report about the health, status and reliability of your hard disk, please refer to SpeedFan. Your hard disk is a Maxtor 6B160P0 with firmware BAH41B10. The average temperature for this hard disk is 37C (MIN=27C MAX=48C) and yours is 34C. Your hard disk's S.M.A.R.T. attributes are now being analyzed and a full report about the reliability, health and status of your hard disk is generated: Your hard disk is not below any attribute threshold. This is good. Your hard disk was never below any attribute threshold. This is good. Your hard disk is now being compared to real data used to define normal values for your specific hard disk model. This way, the analysis can automatically use proper operating ranges. The images give you an idea of how each attribute is within such range. Current and raw values are shown for easier reference for experienced users. There are 2300 hard disk models in the current archive. Attribute Current Raw Overall Spin Up Time 205 9893 Normal Start/Stop Count 253 100 Very good Reallocated Sector Count 253 0 Very good Read Channel Margin 253 0 Very good Seek Error Rate 253 0 Very good Seek Time Performance 246 49259 Good Power On Hours Count 236 36609 Very good Spin Retry Count 253 0 Very good Calibration Retry Count 253 0 Very good Power Cycle Count 253 64 Very good Power Off Retract Count 253 0 Very good Load Cycle Count 253 0 Very good Hardware ECC Recovered 253 1457 Very good Reallocated Event Count 253 0 Very good Current Pending Sector 253 0 Very good Offline Uncorrectable Sector Count 253 0 Very good Ultra DMA CRC Error Rate 199 0 Very good Write Error Rate 253 0 Very good Soft Read Error Rate 253 0 Very good TA Increase Count 253 0 Very good Run Out Cancel 253 0 Very good Shock Count Write Opern 253 0 Very good Shock Rate Write Opern 253 0 Very good Spin High Current 253 0 Very good Spin Buzz 253 0 Very good Offline Seek Performance 240 159 Normal Unknown attribute 210 253 0 Very good Vibration During Write 253 0 Very good Shock During Write 253 0 Very good NOTE: not all warnings are reflected on fitness and performance overall values as relevancy is based upon the settings from the hard disk manufacturer who is the best entity deputed to define such relationships. The overall fitness for this drive is 95%. The overall performance for this drive is 94%.
  3. Allo, Soms start mijn PC correct en ben ik snel in Windows VISTA. Maar vaak weigert hij en blijft na een tijd een leeg scherm over.Als ik dan de PC met de schakelaar afzet en terug aanzet komt na een tijd om mijn sherm: "Op starten met Windows automatisch na 30 seconden of druk op enter " dan verloopt alles naar behoren. Ik veronderstel dat deze harde breaks toch niet gezond zijn voor mijn PC. Wat is de oplossing zodat mijn PC steeds normaal zou opstarten met Vista? henridonne@gmail.com
×
×
  • Nieuwe aanmaken...

Belangrijke informatie

We hebben cookies geplaatst op je toestel om deze website voor jou beter te kunnen maken. Je kunt de cookie instellingen aanpassen, anders gaan we er van uit dat het goed is om verder te gaan.